Instructions:
Textbook:
Manuele, F. A. (2014). Advanced safety management: Focusing on Z10 and serious injury prevention (2nd ed.). Hoboken, NJ: Wiley.
Check before you submit. Get Turnitin Score Report in 15 Minutes.
Don't risk the 'Red' score. Get the exact same Turnitin report your professor uses. Join 50,000+ students who submitted their essays with confidence this semester.
Hazard Analysis and Risk Assessment Project
Be sure to read all of the instructions. There are two documents to be prepared and submitted.
1. Following steps 1-11 of the Hazard Analysis and Risk Assessment Guide in the course textbook (pp. 171-174), develop a risk assessment for a serious workplace hazard with which you are familiar, or use Addendum D to Chapter 11 (pp. 202-206) to help you select a hazard.
2. Evaluate the hazard and its associated risks, and then complete the Hazard Analysis and Risk Analysis Project form is attached.
3. To complete the Initial Risk Assessment and Post Control Risk Assessment sections, use the following codes based on the Risk Assessment Matrix in Table 11.10 (p. 180) of the textbook:
SEVERITY:
1 – Catastrophic
2 – Critical
3 – Marginal
4 – Negligible
PROBABILITY (Likelihood of Occurrence):
A – Frequent
B – Probable
C – Occasional
D – Remote
E – Improbable
RISK CODE:
H – High
S – Serious
M – Medium
L – Low
All sections of the form must be completed. Note that the “Post Control Risk Assessment Measures†section reflects the risk assessment AFTER applying the additional control measures.
4. In a separate document of at least one page, explain the reasoning behind filling out each section of the form, and how would the control measures affect the assessment?
Must use at least the textbook for this assignment, and other resources may be used as needed.
The discussion document is in APA format with a title page and a reference page and any information from a resource is properly cited in APA format.
